Red Copper

Where the cooling towers will be used for? Such as to cool the process water or other fluids for Furnaces, Foundries, HVAC system, Air Compressors, or Other Systems. This is essential to know for a most precise selection, please include all available details, especially the type and power rate or total heat rejection of the system

Cooling Medium Examples: Clean Water, Dirty Water, Refrigerant, Oil, Gas, etc.

How many Tons or m³ / hour, Litres per second or minutes, or gallons per minute?

Temperature of hot fluid inlet to the cooling tower or condenser?

Temperature of cooled water outlet from the cooling tower or condenser, should be at least 3~4 ℃ higher than the wet-bulb temp.

For evaporative cooling, precise highest WBT in summer is necessary to know, If it's not available, please inform us the project installation location instead.

Regular Highest Air Temp. in summer is required to know, but only for drying cooling system.

380V, 3 Phase/50Hz is standard, otherwise please specify, we can meet almost all ranges of the power spec.

Some reminds: - Is it a new project or replacement project? Or are there any footpint limit? -Water supply sufficient or lack of water? - Any other special requirements? (noise level allowed, additional corossion resistance? )