Page Navigation

SuperDyma for Casing of Closed Water Cooling Tower

Publish Time: 2015-06-04     Origin: Site



What is SuperDyma?

 
SuperDyma is a new type of highly corrosion-resistant coated steel sheet with a coating composition consisting of zinc as the main substrate in combination with aluminum (about 11%), magnesium (about 3%) and a trace amount of silicon

Exceptional Resistance to Rust!  
Not only rust resistant on flat surfaces
But also highly rust resistant on cut-end surfaces
In addition, extremely high alkaline resistance

Then corrosion resistance of SuperDyma is enhanced by the composite effect of adding aluminum, magnesium and silicon to the conventional zinc coating. Silicon, among other elements, is highly effective in inhibiting corrosion when combined with Mg.

High Work ability

Strongly resistant to rust at bends and in cylindrically-drawn sections; fine finishes with fewer scratches after fabrication
Distinguished weld ability and paint ability

SuperDyma offers high coating adherence that can withstand severe fabricating processes. The coating has a high degree of hardness, thus offering excellent scratch resistance.

Form Name

Where the cooling towers will be used for? Such as to cool the process water or other fluids for Furnaces, Foundries, HVAC system, Air Compressors, or Other Systems. This is essential to know for a most precise selection, please include all available details, especially the type and power rate or total heat rejection of the system

Cooling Medium Examples: Clean Water, Dirty Water, Refrigerant, Oil, Gas, etc.

How many Tons or m³ / hour, Litres per second or minutes, or gallons per minute?

Temperature of hot fluid inlet to the cooling tower or condenser?

Temperature of cooled water outlet from the cooling tower or condenser, should be at least 3~4 ℃ higher than the wet-bulb temp.

For evaporative cooling, precise highest WBT in summer is necessary to know, If it's not available, please inform us the project installation location instead.

Regular Highest Air Temp. in summer is required to know, but only for drying cooling system.

380V, 3 Phase/50Hz is standard, otherwise please specify, we can meet almost all ranges of the power spec.

Some reminds: - Is it a new project or replacement project? Or are there any footpint limit? -Water supply sufficient or lack of water? - Any other special requirements? (noise level allowed, additional corossion resistance? )

Related Articles

Red Copper

Stainless Steel

SuperDyma for Casing of Closed Water Cooling Tower

MX75